Chapter 104. WSRR Server configuration mode
This chapter provides an alphabetic listing of commands that are available in
WSRR Server configuration mode. While in this configuration mode, provide the
information to access a WSSR server. To enter this configuration mode, use the
Global wsrr-server command.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in WSSR Server configuration mode.
password
Specifies WSRR server credentials.
Syntax
password passphrase
Parameters
passphrase
Guidelines
Used in conjunction with username command to provide the credentials used to
access the WSRR Server.
Required when the WSRR server enforces authentication.
Related Commands
username
server-version
Identifies the WSRR server version.
Syntax
server-version {WSRR_6.0 | WSRR_6.1}
Parameters
WSRR_6.0
WSRR_6.1
Guidelines
The server-version command specifies the version of the WSRR server.
© Copyright IBM Corp. 1999, 2008
Specifies the user password.
(Default) Uses WSRR Server, version 6.0.
Uses WSRR Server, version 6.1 or later.
883