Table of Contents
Advertisement
Examples
v Sets the ARP retry limit to 5.
destination-routing
Controls the behavior of destination-based routing.
Syntax
destination-routing {on | off}
Parameters
on
off
Related Commands
relax-interface-isolation
Examples
v Ensures that outbound packets originate from an interface bound to an address
disable-interface-isolation
Controls interface isolation.
Syntax
disable-interface-isolation {on | off}
Parameters
on
off
490
Command Reference
# arp-retries 5
#
Selects the interface based on the best path to the client, irrespective of the
service or receiving interface. Best path is determined by static routes
bound to the available interfaces.
Note: Destination-based routing is for backward compatibility only. Enable
destination-based routing only if an upgrade disables existing
connectivity.
(Default) Selects the interface based on the interface that is bound to the
address of the service that generated the response. If the service is bound
to a single address, responses are routed using the interface that is
assigned to that address. If the service is bound to more than one address
(a configuration of 0.0.0.0), responses are routed using the interface that
received the original client request (not the interface that is bound to the
service that generated the response).
of the service that created the packet.
# destination-routing off
#
Enables interface-isolation.
(Default) Disables interface-isolation.
Advertisement
Table of Contents
