Table of Contents
Advertisement
Chapter 79. Telnet Service configuration mode
This chapter provides an alphabetic listing of commands that are available in
Telnet Service configuration mode.
To enter this configuration mode, use the Global cli telnet command. While in
Telnet configuration mode, define a Telnet server that supports client-initiated
access to the command line interface.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in Telnet Service configuration mode.
acl
Assigns an Access Control List (ACL).
Syntax
acl name
Parameters
name
Guidelines
Assignment of an ACL to a Telnet Service is optional. If an ACL is assigned to the
service, only those IP addresses specifically allowed by the ACL can initiate Telnet
access to the appliance; if an ACL is not assigned, Telnet access to the appliance is
unrestricted.
Related Commands
acl (Global), allow (ACL), deny (ACL)
ip-address
Specifies the local IP address to monitor for incoming CLI traffic.
Syntax
ip-address {address | 0}
Parameters
address Specifies the IP address (primary or secondary) of a DataPower Ethernet
0
Guidelines
In conjunction with the port command, identifies the IP addresses and ports that
the Telnet service monitors.
© Copyright IBM Corp. 1999, 2008
Specifics the name of an ACL.
interface.
Indicates all DataPower Ethernet interfaces.
671
Advertisement
Table of Contents
