Table of Contents
Advertisement
Syntax
move [-f] source-URL destination-URL
Parameters
-f
source-URL and destination-URL
Guidelines
You can use the move command to transfer a file to or from a directory. However,
you cannot use the move command to copy a file from the private cryptographic
area (such as the cert: directory).
Related Commands
copy, delete, dir
Examples
v Moves a file from the config: directory to the store: directory.
v Renames a file.
mpgw
Enters Multi-Protocol Gateway configuration mode.
Syntax
mpgw name
no mpgw name
Parameters
name
72
Command Reference
Overwrites an existing file, if one of the same name already exists.
In the absence of this argument, an attempt to save a file with the same
name as an existing file results in a prompt that requests confirmation to
overwrite the existing file.
Specifies the URLs that identify the source file and target destination,
respectively. These arguments take the following form:
directory:///filename
directory
Specifies a directory on the appliance. Refer to "Directories on the
appliance" on page xxii for details.
filename
Specifies the name of a file in the specified directory.
# move config:///startup-config store:///archiveConfig-10
#
# move config:///startup-config config:///archiveConfig-10
#
Specifies the name of the Multi-Protocol Gateway.
The name can contain a maximum of 128 characters. For restrictions, refer
to "Object name conventions" on page xxiv.
Advertisement
Table of Contents
