Table of Contents
Advertisement
Syntax
wsrm-sequence-expiration lifetime
Parameters
lifetime Specifies the lifetime in seconds. The default is 3600.
Guidelines
If an incoming CreateSequence SOAP message has an Expireslifetime that is longer
than this value, the value in the SequenceResponse SOAP message is reduced to
this value. The same process applies to the Expireslifetime in any accepted Offer
in an incoming CreateSequence and for the requested Expires value in any
CreateSequence SOAP call that is made to the client or server from a Reliable
Messaging source. This implementation never requests or accepts a non-expiring
sequence (a value of PT0S that represents zero seconds).
Related Commands
wsrm
wsrm-source-back-acks-to
Specifies the name of the Front Side Protocol Handler to receive responses from the
server.
Syntax
wsrm-source-back-acks-to handler
Parameters
handler
Guidelines
The wsrm-source-back-acks-to command identifies the Front Side Protocol
Handler to receive the asynchronous Reliable Messaging SequenceAcknowledgement
SOAP responses from the server. The Front Side Protocol Handler must be
associated with the same DataPower service where the corresponding Reliable
Messaging sequence is occurring.
This property controls whether the backside Reliable Messaging source uses a
unique URL to receive asynchronous Acks from the server Reliable Messaging
destination, or whether Acks are sent synchronously in future responses to the
backside server.
v With a specified Front Side Protocol Handler and the response process causes a
v Without a Front Side Protocol Handler, the AcksTo element has the value
Related Commands
wsrm
Specifies the name of an existing Front Side Protocol Handler.
CreateSequence SOAP message to be sent, the AcksTo element of the
CreateSequence SOAP message will be set to the URL that is specified in back
AcksTo.
http://www.w3.org/2005/08/addressing/anonymous, which indicates synchronous
Acks.
Chapter 49. Multi-Protocol Gateway configuration mode
481
Advertisement
Table of Contents
