Table of Contents
Advertisement
Syntax
wsa-strip-headers {on | off}
Parameters
on
off
Guidelines
This command is relevant when the DataPower service is positioned between users
of WS-Addressing and a nonusers; that is when the WS-Addressing mode, as
specified by the wsa-mode command, is wsa2sync or sync2wsa.
Note: WS-Reliable Messaging requires the termination of WS-Addressing
Related Commands
wsa-force, wsa-mode
Examples
v Changes the default state. Retains all WS-Addressing headers contained in
v Restores the default state. Deletes all WS-Addressing headers contained in
wsa-timeout
Specifies the asynchronous timeout value.
Syntax
wsa-timeout timerValue
Parameters
timerValue
(Default) Enables the deletion of WS-Addressing headers from an incoming
message.
Disables the deletion of WS-Addressing headers from an incoming
message.
sequences. Changing the default value can break interoperability.
incoming messages.
# wsa-strip-headers off
#
or
# no wsa-strip-headers
#
incoming messages.
# wsa-strip-headers on
#
or
# wsa-strip-headers
#
Specifies the maximum wait period in seconds. Use an integer in the range
of 1 through 4000000. The default is 120.
Chapter 49. Multi-Protocol Gateway configuration mode
475
Advertisement
Table of Contents
