Chapter 90. VLAN configuration mode
This chapter provides an alphabetic listing of commands that are available in
VLAN configuration mode.
To enter this configuration mode, use the global vlan-sub-interface command.
In this configuration mode, all of the commands that are in "Common commands"
on page 2 and most, but not all, of the commands that are in Chapter 114,
"Monitoring commands," on page 949 are available.
arp
Enables or disables ARP.
Syntax
arp
no arp
Guidelines
The arp command enables or disables the Address Resolution Protocol (ARP) on
all IP interfaces that are provided by the current VLAN port.
By default, ARP is enabled. Certain network topologies and load-balancing
configurations might require that you disable ARP.
To disable, use the no arp command.
Related Commands
vlan-sub-interface, show netarp
Examples
v Disables ARP.
v Enables ARP (restores default state).
dhcp
Enables or disables the DHCP client.
Syntax
dhcp
no dhcp
© Copyright IBM Corp. 1999, 2008
# no arp
#
# arp
#
731