Table of Contents
Advertisement
Chapter 106. XML Firewall configuration mode
This chapter provides an alphabetic listing of commands that are available in XML
Firewall configuration mode.
To enter this configuration mode, use the global xmlfirewall command.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in XML Firewall configuration mode.
acl
Assigns an ACL.
Syntax
acl name
no acl
Parameters
name
Guidelines
An ACL restricts access to those IP addresses specified by the ACL. You can assign
a single ACL to an XML Firewall.
Use the no acl command to remove the ACL/XML Firewall assignment.
Related Commands
acl, allow, deny
attachment-byte-count
Specifies the XML Firewall-specific maximum size for an attached document.
Syntax
attachment-byte-count bytes
Parameters
bytes
Guidelines
Attachments that exceed the specified size result in a failure of the entire
transaction. A value of 0 indicates that no size limit is enforced.
© Copyright IBM Corp. 1999, 2008
Specifies the name of the ACL.
Indicates the maximum number of bytes to allow in any attachment. The
default is 2000000000.
893
Advertisement
Table of Contents
