Table of Contents
Advertisement
Chapter 49. Multi-Protocol Gateway configuration mode
This chapter provides an alphabetic listing of commands that are available in
Multi-Protocol Gateway configuration mode.
To enter this configuration mode, use the Global mpgw command. This global
command creates the specified Multi-Protocol Gateway, if it currently does not
exist. While in this mode, you use the commands to define the configuration of a
new or an existing Multi-Protocol Gateway.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are available in this configuration mode.
attachment-byte-count
Defines the maximum number of bytes to allow in attachments.
Syntax
attachment-byte-count bytes
Parameters
bytes
Guidelines
The attachment-byte-count command defines the maximum number of bytes to
allow in a single attachment. Attachments that exceed this size result in a failure of
the entire transaction. Only available when parser limits are enabled.
Related Commands
gateway-parser-limits
Examples
v Sets the maximum attachment size for the current Multi-Protocol Gateway to
attachment-package-byte-count
Defines the maximum number of bytes to allow for all parts of an attachment
package.
Syntax
attachment-package-byte-count bytes
© Copyright IBM Corp. 1999, 2008
Specifies the maximum number of bytes allowed in any single attachment.
If this value is 0, no limit is enforced. The default is 2000000000.
5000000 bytes. Any attachment that passes through the gateway can be no larger
than 500000 bytes. If larger, the message will be rejected.
# attachment-byte-count 500000
#
435
Advertisement
Table of Contents
