Table of Contents
Advertisement
Chapter 97. Web Management Service configuration mode
This chapter provides an alphabetic listing of commands that are available in Web
Management Service configuration mode. To enter this configuration mode, use the
Global web-mgmt command.
All of the commands that are listed in "Common commands" on page 2 and most,
but not all, of the commands that are listed in Chapter 114, "Monitoring
commands," on page 949 are also available in Web Management Service
configuration mode.
idle-timeout
Specifies the amount of idle time before closing a WebGUI session because of
inactivity.
Syntax
idle-timeout seconds
Parameters
seconds
local-address
Identifies the local address to monitor for requests.
Syntax
local-address address:port
Parameters
address:port
Guidelines
You can use the special IP address 0.0.0.0 to specify all local addresses.
Examples
v Specifies that port 8090 on all interfaces is monitored for incoming Web
© Copyright IBM Corp. 1999, 2008
Specifies the timeout value of the idle session in seconds. Use an integer in
the range of 0 through 65535.
Specifies the IP address and port number monitored for incoming Web
Management Service requests.
Management Service requests.
# web-mgmt
Web Management Service configuration mode
# local-address 0.0.0.0:8090
#
781
Advertisement
Table of Contents
