Table of Contents
Advertisement
Syntax
Enter the configuration mode to create or modify VLAN objects
Delete VLAN objects
Disable VLAN objects
Parameters
name
Guidelines
The vlan-sub-interface command is available in Global configuration mode. The
vlan-sub-interface command enters Virtual LAN (VLAN) configuration mode.
While in VLAN configuration mode, you can create or modify VLAN objects. Use
the no vlan-sub-interface command to delete a VLAN object.
A VLAN object is generally used to provide a trunk between adjacent DataPower
appliances. The VLAN object creates a virtual IP interface (VIP) on one of the
physical Ethernet interfaces on the appliance. VLAN packets are identified by the
IEEE 802.1Q tagging protocol.
You can create multiple VLAN objects on a single Ethernet interface.
To exit the configuration mode and not apply the changes, use the cancel
command. To apply the changes and exit the configuration mode, use the exit
command. Using either command returns you to Global configuration mode.
Related Commands
cancel, exit, show vlan-interface, show vlan-sub-interface
watchdog
Sets watchdog timeout values.
Syntax
watchdog soft-timeout hard-timeout
Parameters
soft-timeout
hard-timeout
130
Command Reference
vlan-sub-interface name
no vlan-sub-interface name
disable vlan-sub-interface name
Note: The Admin State of Ethernet interfaces can be set from enabled to
disabled while Ethernet cables are still physically connected to the
appliance. Use this method of removing the appliance from the
network without physically removing network cables.
Specifies the name of the VLAN object.
The name can contain a maximum of 128 characters. For restrictions, refer
to "Object name conventions" on page xxiv.
Specifies the soft timer value.
Specifies the hard timer value.
Advertisement
Table of Contents
