Firmware Flash Log Messages; Flash Certificate, Configuration, And Storage Log Messages - HP ProLiant Gen9 Troubleshooting Manual

Firmware flash log messages

Log type: LOG_ALERT, Failure type: SW
FWSync: OA firmware sync flash failed and system is in an unstable state. Do not
reboot! Try to flash again with a new image.
OA_Flash: Flash failed and system is in an unstable state. Do not reboot!Try to
flash again with a new image.
Log type: LOG_ERR, Failure type: SW
FWSync: Error opening OA firmware sync image.
FWSync: Error opening OA firmware sync image.
FWSync: Invalid flash image.
FWSync: OA firmware sync image is corrupted.
FWSync: OA firmware sync image is older than current firmware.
FWSync: Only one flash instance can run at a time.
FWSync: Only one instance of OA firmware sync can run at a time.
OA_Flash: Downloading flash image failed.
OA_Flash: Error opening [value] for input.
OA_Flash: Firmware image is corrupted or not a valid image. Please verify the
url and try again.
OA_Flash: Firmware version [value:version] is not supported on this hardware.
OA_Flash: Found core file. Reboot after flash suppressed to allow developer to
debug.
OA_Flash: Invalid flash image.
OA_Flash: Invalid flash image.
OA_Flash: Only one flash instance can run at a time.
OA_Flash: Out of memory while decoding flash image.
OA_Flash: The firmware image provided is older than the current firmware and OA
settings cannot be preserved. The force downgrade option must be used. Please
re-try with the force option to flash and go back to factory defaults.
Log type: LOG_NOTICE, Failure type: Info
FWSync: New firmware image flashed.
FWSync: OA firmware sync to [value:version] complete
OA_Flash: Firmware image flashed from [value:version] to [value:version]
Log type: LOG_INFO, Failure type: Info
OA_Flash: Image verified successfully and applies to this system using the
parameters supplied. Test Mode specified, skipping the actual flash process
Firmware version [value:version] ExitCode=0

Flash certificate, configuration, and storage log messages

Log type: LOG_ERR, Failure type: SW
CERTS: .ssh has wrong directory permissions
HP Onboard Administrator errors 181