HP ProLiant Gen9 Troubleshooting Manual page 212

Trap name
vcModOutputErrorsDown
vcModPortBpduLoopDetected port identification
vcModPortBpduLoopCleared
vcModPortProtectionConditio
nDetected
vcModPortProtectionConditio
nCleared
vcSwitchMemParityErrorEvent Error counter
VC Domain MIB traps
The Virtual Connect vc-domain-mib.mib MIB provides visibility into the various components of a Virtual
Connect Domain.
VC Domain Managed Status Changed traps
This section describes the *ManagedStatus, *Cause, *RootCause, and *ReasonCode OIDs found in each
*ManagedStatusChanged traps in the VC Domain MIB.
The ManagedStatus enumerations (vcDomainManagedStatus, vcEnclosureManagedStatus, and so on) for
all managed status changed objects (vcDomainManagedStatusChanged,
cEnclosureManagedStatusChanged, and so on) are described in the following table.
Managed status
unknown
normal
warning
minor
major
Trap data
port identification
ifOutErrors
loop status
port identification
loop status
Port index to the
ifTable (ifIndex)
Port index to the
vcModulePortTable
Port protection status
Port index to the
ifTable (ifIndex)
Port index to the
vcModulePortTable
Port protection status
vcSwitchMemParityEr
rorCount
Description
Indicates the condition of the component could not be determined
Indicates the component is fully functional
Indicates a component threshold has been reached or error condition is imminent
Indicates an error condition exists that has little or no component impact
Indicates an error condition exists that significantly impairs the component
Description
The output error count on a port has dropped below its
low-water mark for longer than 30 seconds. port is the
index of the affected port in ifTable.
A network loop condition is detected on this port. If the
loop condition is detected on a Flex10 port, the trap data
indicates the physical port associated with the Flex10
port.
If multiple Flex10 ports on a physical port detect a loop
condition, a separate trap is sent for each occurrence of
the loop condition.
A network loop condition is cleared on this port. The trap
data indicates the physical port associated with a Flex10
port.
For Flex10 ports, this trap is sent only after all Flex10
ports on a physical port are cleared from a loop
condition.
A port protection condition is detected on this port. If the
new port protection status is a value other than OK, the
port may be disabled to protect the VC module from
further service degradation. Administrative action is
required to recover the port from this condition.
The port is recovered from port protection condition to
normal operational state.
The switch hardware has detected a parity error. The
parity error is automatically corrected.
HP Virtual Connect errors 212