HP ProLiant Gen9 Troubleshooting Manual page 186

OA: Failed to register for events on the Standby Onboard
Administrator(error=0x[value])
OA: Failed to send URB message to configured endpoint. Check URB settings.
OA: Firmware image corrupt. Please verify the image and retry
OA: Please inspect the system log on the Standby Onboard Administrator for further
details
OA: The Active and Standby Onboard Administrators may not be communicating
reliably
OA: The Onboard Administrator in bay %d has been reset via e-fuse by user [value].
OA: LDAP Server Timed Out.
Log type: LOG_WARNING, Failure type: Info
FWSync: OA firmware sync initiated by user [value:username]
FWSync: Other (STANDBY) OA will be upgraded to firmware [value:versionNumber]
FWSync: This (ACTIVE) OA will be upgraded to firmware [value:versionNumber]
OA: Flashing Active Onboard Administrator. Initiated by user [value:username]
OA: Flashing Standby Onboard Administrator. Initiated by user [value:username]
Log type: LOG_CRIT, Failure type: SW
OA: Enclosure Name change failed.
OA: Failed NVRAM commit of Enclosure Dynamic Power Cap bay opt out list by
[value:username].
OA: Failed to reset the Onboard Administrator.
OA: Rack Name change failed
Log type: LOG_CRIT, Failure type: Info
Log cleared by [value:username].
OA: CA certificate (issuer = [value:issuer-CN]) installed by user
[value:username].
OA: CA certificate (issuer = [value:issuer-CN]) removed by user [value:username].
OA: Certificate for user [value:username] installed by user [value:username].
OA: Certificate for user [value:username] removed by user [value:username]. All
web sessions (if any) were ended.
OA: Certificate owner field set to ([SAN/SUBJECT]) on Onboard Administrator by
user [value:username].
OA: Certificate Revocation check [enabled/disabled] on Onboard Administrator by
user [value:username].
OA: Downloaded HPSIM certificate by user [value:username]
OA: Enclosure Dynamic Power Cap bay opt out list set to [value] by
[value:username].
OA: Enclosure Dynamic Power Cap set to: [value], derated circuit [value], rated
circuit [value] by [value:username].
OA: Enclosure Dynamic Power Cap set to: OFF by [value:username].
OA: Enclosure part number changed from '[value]' to '[value]' by
[value:username].
HP Onboard Administrator errors 186