HP ProLiant Gen9 Troubleshooting Manual page 174

543 This version of Onboard Administrator firmware does not support boot options for servers configured in
UEFI boot mode.
561 Transmission from the HP Insight Remote Support receiver was unsuccessful.
562 Transmission from the HP Insight Remote Support receiver was unsuccessful. Please check connectivity
between OA and the Insight Remote Support receiver.
563 The key strength for the provided key is invalid for this configuration.
564 This command is not supported by the interconnect.
565 The string entered is a link-local address and cannot be used for assignment.
566 Invalid IPv6 static route gateway. Route gateway must not be empty and must not contain prefix length.
567 IPv6 static route destination already exists.
568 Unable to add IPv6 route. The maximum number of IPV6 static routes already exist.
569 IPv6 static route not found.
570 Invalid IPv6 static route destination. The route destination must be a valid IPv6 address.
571 All items cannot be disabled.
572 This action requires the OA to be in FIPS Mode ON/DEBUG.
573 Must set MINRATE option if using timeout range.
574 Minimum data rate must be larger than 0.
575 Maximum timeout must be larger than minimum timeout.
576 Timeout must be larger than 0.
577 HTTP Read Timeout is already set to the requested value.
Insight Display screen shot errors
1 Missing credentials.
2 The getLCDImage CGI process has caught the SIGSEGV signal.
3 Could not acquire access to the image in a reasonable amount of time.
4 Cannot open semaphores.
5 Produce SEMV does not work.
6 Consume SEMV does not work.
7 Cannot lock the image file.
8 Cannot open the image file.
9 Cannot seek in the image file.
10 Unable to resume session.
11 Insufficient privileges.
HP Onboard Administrator errors 174