HP ProLiant Gen9 Troubleshooting Manual page 187

OA: Enclosure PDU type changed from '[value]' to '[value]' by [value:username].
OA: Forced takeover requested by user [value:username].
OA: HP SSO certificate [value:subject-CN] added by user [value:username].
OA: HP SSO certificate [value] removed by user [value:username].
OA: LDAP Directory Server certificate(MD5=[value]) installed by user
[value:username].
OA: LDAP Directory Server certificate(MD5=[value]) removed by user
[value:username].
OA: Onboard Administrator [value:bayNumber] name change failed.
OA: Resetting the Onboard Administrator because two-factor authentication
configuration has changed.
OA: Self signed certificate generated and installed by user [value:username].
OA: Time changed by [value:username].
OA: Time zone changed by [value:username].
OA: Time zone changed from [value] to [value]
OA: Time zone changed to [value]
OA: Two Factor Authentication [enabled/disabled] on Onboard Administrator by user
[value:username].
Log type: LOG_NOTICE, Failure type: SW
FWSync: Sync failed because the Active and Standby OAs do not have the same
hardware version.
OA: unable to run [value:mount]
OA: Warning: Unable to ping the remote oa_syslog server [value:Address]
Log type: LOG_NOTICE, Failure type: Info
FWSync: OA firmware sync to [value:versionNumber] complete
OA: [value:protocol] was [enabled/disabled] by user [value:username]
OA: Alertmail domain changed to [value:mailDomain] by user [value:username]
OA: Alertmail recipient changed to [value] by user [value:username]
OA: Alertmail server changed to [value:mailServer] by user [value:username]
OA: Default VLAN ID for enclosure changed to [value]
OA: DHCPv6 was [enabled/disabled] by user [value:username].
OA: EBIPA Interconnect DNS [value:bladeNumber] [value] [value] by user
[value:username]
OA: EBIPA Interconnect Domain [value] [value] by user [value:username]
OA: EBIPA Interconnect domain for bay [value:bladeNumber] set to [value] by user
[value:username]
OA: EBIPA Interconnect first DNS IP for bay [value:bladeNumber] set to [value]
by user [value:username]
OA: EBIPA Interconnect first NTP IP for bay [value:bladeNumber] set to [value]
by user [value:username]
OA: EBIPA Interconnect gateway for bay [value:bladeNumber] set to [value] by user
[value:username]
HP Onboard Administrator errors 187