HP ProLiant Gen9 Troubleshooting Manual page 397

Log Severity: Error (3)
Log Message: Connectivity has been lost for the NIC in slot %1, port %2.
SNMP Trap: cpqNic3ConnectivityLost - 18012 in CPQNIC.MIB
Symptom: This trap is sent any time the status of a logical adapter changes to the Failed condition. This occurs
when the adapter in a single adapter configuration fails, or when the last adapter in a redundant
configuration fails. This can be caused by loss of link due to a cable being removed from the adapter or the
Hub or Switch. Internal adapter, Hub, or Switch failures can also cause this condition.
User Action: Check the cables to the adapter and the Hub or Switch. If no cable problems are found, the
adapter, Hub, or Switch may need replacement.
Supporting SNMP Trap Data:
•
sysName
•
cpqHoTrapFlags
•
cpqNicIfPhysAdapterSlot
•
cpqNicIfPhysAdapterPort
•
cpqSiServerSystemId
•
cpqNicIfPhysAdapterStatus
•
cpqSePciSlotBoardName
•
cpqNicIfPhysAdapterPartNumber
•
ipAdEntAddr
•
cpqNicIfLogMapIPV6Address
Supporting SNMP Trap Description: "Connectivity lost for adapter in slot [cpqNicIfPhysAdapterSlot], port
[cpqNicIfPhysAdapterPort]."
NT Event ID: 1292 (Hex)0x4435050C (cpqnimsg.dll)
Log Severity: Information (1)
Log Message: Redundancy has been increased by the NIC in slot %1, port %2. Number of functional NICs
in the team: %3.
SNMP Trap: cpqNic3RedundancyIncreased - 18013 in CPQNIC.MIB
Symptom: This trap is sent any time a previously failed physical adapter in a connected logical adapter
group returns to the OK condition. This trap is not sent when a logical adapter group has connectivity
restored from a Failed condition. The cpqNicConnectivityRestored trap is sent instead. This can be caused by
replacing of a faulty cable or connecting a cable that was disconnected.
User Action: None required.
Supporting SNMP Trap Data:
•
sysName
•
cpqHoTrapFlags
•
cpqNicIfPhysAdapterSlot
•
cpqNicIfPhysAdapterPort
•
cpqSiServerSystemId
Microsoft Windows Event ID and SNMP traps 397