HP ProLiant Gen9 Troubleshooting Manual page 197

OA: Blade [value:bladeNumber] cannot be powered on at this time due to location
rules.
OA: Blade [value:bladeNumber] has been allocated a default power value of [value]W
because iLO appears unresponsive.
OA: Blade [value:bladeNumber] is missing a Scalable Blade Link.
OA: Blade [value:bladeNumber] is not configured for Virtual Connect Manager.
OA: Blade [value:bladeNumber] requires a proper mezzanine card to partner.
OA: Blade [value:bladeNumber] requires partner in bay [value:bladeNumber] to be
powered on first.
OA: Blade [value:bladeNumber]: SMBIOS data carries more than [value] CPU records
which cannot be processed with this OA firmware version.
OA: Blade [value:bladeNumber]: SMBIOS data carries more than [value] DIMM records
which cannot be processed with this OA firmware version.
OA: Blade [value:bladeNumber]: SMBIOS data carries more than [value] NIC records
which cannot be processed with this OA firmware version.
OA: Blade [value:bladeNumber]: SMBIOS data requires [value] DIMM records. [value]
are supported by this OA firmware version.
OA: Enclosure Dynamic Power Cap: Device tray firmware doesn't meet minimum
required version.
OA: Enclosure Dynamic Power Cap: Server Power Reduction is not enabled; enclosure
cap is not guaranteed if power redundancy is lost.
OA: Fan Inserted: Bay #[value:fanNumber]
OA: iLO in bay [value:bladeNumber] appears responsive to the Enclosure Dynamic
Power Cap again.
OA: iLO in bay [value:bladeNumber] is not responding to capping requests from
the Enclosure Dynamic Power Cap. Reset the iLO.
OA: Server Power Reduction - Deactivated
OA: Tray Update: Can't get TRAY PS microcode version
OA: Warning: integrated device on bus 0x[value] at address 0x[value] has not
responded
Log type: LOG_NOTICE, Failure type: Info
OA: AC Subsystem Overloaded - REPAIRED
OA: Blade [value:bladeNumber] Ambient Temperature Cable state is OK.
OA: Blade [value:bladeNumber] Ambient Temperature Sensor state is OK.
OA: Blade [value:bladeNumber] Ambient Temperature state is OK.
OA: Blade [value:bladeNumber] cannot be managed as part of the Enclosure Dynamic
Power Cap. The blade is not a supported model.
OA: Blade [value:bladeNumber] cannot be managed as part of the Enclosure Dynamic
Power Cap. The blade reports that it is not capable of dynamic power capping.
OA: Blade [value:bladeNumber] cannot be managed as part of the Enclosure Dynamic
Power Cap. The blade does not have the required iLO license.
OA: Blade [value:bladeNumber] complies with location rules now.
OA: Blade [value:bladeNumber] Disk Tray is Open state is OK.
OA: Blade [value:bladeNumber] firmware management completed.
HP Onboard Administrator errors 197