HP ProLiant Gen9 Troubleshooting Manual page 135

•
PHY_RESET_FAILED - Phy reset request failed.
•
FR_CHKBLK_FAILED_WRITE - Drive failed write command while checking for media
errors.
•
FR_ATI_TEST_FAILED_WRITE - Drive failed write command while checking for
errors.
•
OFFLINE_ERASE - Drive is offline due to a Secure Erase operation.
•
OFFLINE_TOO_SMALL - Drive is offline because it's a replacement drive that
is too small.
•
OFFLINE_DRIVE_TYPE_MIX - Drive is offline because it is not the correct type
for this array [SATA vs SAS].
•
OFFLINE_ERASE_COMPLETE - Drive is offline because a Secure Erase operation
has completed on it but it hasn't been replaced yet.
Message Id: 24710
Severity: Informational
Log message:
The external Smart Array controller located in the MSA chassis labeled as <chassis
label> has reported that logical drive <logical drive number> has encountered
a status change from:
Status: <previous status>
to
Status: <current status>
The external Smart Array controller is attached to the host side Smart Array
controller <controller name / slot information>.
<previous status> and <current status> values:
•
"OK"
•
"FAILED"
•
"NOT CONFIGURED"
•
"INTERIM RECOVERY MODE"
•
"READY FOR RECOVERY"
•
"RECOVERING"
•
"WRONG PHYSICAL DRIVE REPLACED"
•
"PHYSICAL DRIVE NOT PROPERLY CONNECTED"
•
"HARDWARE IS OVERHEATING"
•
"HARDWARE HAS OVERHEATED"
•
"EXPANDING"
•
"NOT YET AVAILABLE"
•
"QUEUED FOR EXPANSION"
•
"DISABLED DUE TO SCSI ID CONFLICT"
•
"EJECTED"
HP Smart Array errors 135