Setting Http Port For Meap Application (Level 2); Port Setup Procedure Of Http Server - Canon imageRUNNER ADVANCE C5045 Series Service Manual

2

Setting HTTP port for MEAP application (level 2)

For the ports in which the MEAP application uses, the default is 8000 for the port on HTTP
server, and 8443 for the port on HTTPS server. In the case that these ports have already
used by the customer who is to introduce this application, the MEAP application cannot use
the HTTP (or HTTPS) server(s).
By changing the following ports to use, however, the MEAP application can be used as well
as the existing system.
HTTP server
Setting value is 0 through 65535 [the value at factory shipment/after clearing RAM: 8000]
MEMO:
Do not use port number"8080" when PS print server unit is connected. If the port
is used, you can not see the page for RUI of the device with MEAP authen-tication
application. (port "8080" is reserved for redirecting from PS print server unit to device.)
HTTPS server
Setting value is 0 through 65535 [the value at factory shipment/after clearing RAM: 8443]
MEMO:
As for port on HTTPS server, it only applies to the device that supports SSL function.

Port setup procedure of HTTP Server

1) Startup level 2 of [SERVICE MODE] . The start procedure of [SERVICE MODE] level2 is as
follows.
1. Press [Settings /Registration] button n control panel.
2. Press [2] button and [8] button at the same time on control panel.
3. Press [Settings /Registration] button.
4. [SERVICE MODE] screen is displayed.
5. Press [Settings /Registration] button.
6. Press [2] button.
2
2) Press [COPIER] >[Option] > [NETWORK] buttons.
button until [MEAP-PN] is shown on the screen. Press [MEAP-PN]
3) Press or
button.
4) Press the port number to specify on the control panel (the numerical value input in the field
is displayed), and press [OK] button.
2-143
F-2-225
F-2-226
F-2-227
2-143