Backup Items; Requirements For Backup Using The Sst; Making A Backup And Formatting Hard Disk Drive With Service Support Tool - Canon imageRUNNER ADVANCE C5045 Series Service Manual

2

Backup Items

The following items are backed up using SST:
jar files of MEAP applications
•
Setup data generated by MEAP applications (Note that image data stored in BOX will not
•
be saved for MEAP applications using BOX function).
• User information data registered for local device authentication in SSO-H

Requirements for Backup Using the SST

The following conditions must be met for use of the function:
1)Device Firmware Version
Device Firmware Version for SST (Ver4.2x)
Boot ROM
image Runner Already supported
Advanced series since the 1st version.
2)SST Version
Version 1.81 or later. An earlier version will not permit the use of the function. If needed,
upgrade the SST.
3)Space for backup
To back up the HDD of the iR, the PC must have approx 1024MB of free space at maximum.
Sizes of backup files depend on actual data capacities to be backed up.
Making a Backup and Formatting Hard Disk Drive with Service
Support Tool
1)Switching Login Service / Backup of Login User Information
If SSO-H is used for the login service, switch to default authentication before backing up the
user information. Although SST will back up local device user information, it is recommended
to export the user information just in case. For local device user information backup, go to
User Management page of SSO-H site and export the data. (The SSO-H login page opens
with the URL "http://<device IP address>:8000/sso/").
2
System SST
Already supported The version supporting
since the 1st version. the corresponding
devices.
If a hard disk of a system that uses SSO-H is formatted without changing the login
•
service to the default authentication, the error message "The login service must be
set again with SMS" appears and the system cannot start up when you attempt to
restart the system after formatting.
If this problem occurs, change the login service to SSO-H with SMS. If you cannot
•
access to SMS since you do not have the IP address of the device, start the system
with FIXIP mode -hold down the numeric keys 1 and 7 and turn the power switch on.
The IP address "172.16.1.100" will be automatically assigned for the device. Then
log in to SMS specifying the address.
2)Starting the device in Download Mode
Press [2] and [8] buttons at the same time on the control panel and turn on the main power
switch to start the device in Download Mode. Note that SST backup function is enabled only
in Download Mode.
3) Connecting the main unit to the PC to start SST
T-2-76 T-2-76
Connect the main unit to the PC with SST installed using the crossing cable and the like to
start SST on the PC.
4) Connecting the device using SST
When starting SST, select the target device type as Single and click [Start] button.
2-138
F-2-215 F-2-215
2-138