Initialization Of Meap Driver Priority Registration; Specifications For The Use Of Usb Keyboards - Canon imageRUNNER ADVANCE C5045 Series Service Manual

2
Availability for MEAP applications of USB devices B and C (either HID keyboard or Mass
Storage) plugged to iR device
Registration Setting to use USB Native
status of MEAP driver device application
USB device (Additional
B Functions
mode)
YES
Registered Not used B
YES
(Native driver
C
to be used)
To be used B NO
C NO
Not Not used B NO
YES
registered (Native driver
C
to be used)
To be used B NO
C NO
YES ＝ USB device available
NO ＝ USB device not available

Specifications for the use of USB keyboards

Characters that could be entered on the software keyboard displayed on the conventional
control panel can be entered using a USB connected keyboard.
When the software keyboard window is displayed, characters can be entered from the USB
•
keyboard (in-line entry not possible).
When the software keyboard window is not displayed, entered characters will not be
•
remembered.
The characters, which can be entered from a USB keyboard, is only a character, which can
•
be entered from the software keyboard.
Even if characters are entered from the USB keyboard, the software keyboard window will
•
not change (the corresponding key does not invert or change color).
Input from the USB keyboard can be accepted at the same time as input from the software
•
keyboard or numeric keys.
Since the device supports Plug and Play, the USB keyboard can be disconnected/
•
connected freely. However, do not disconnect and connect during in deep sleep (when
in sleep with setting "low" at "the power consumption in sleep"). It is out of an operation
guarantee to disconnect and connect the USB keyboard in deep sleep.
Keyboard layout is English. Moreover, the function key or the numeric key, which are not
•
displayed on the software keyboard, cannot be used. (Although the keyboard, which used
for operation check, is 84 keyboard, it does not mean to guarantee the operation with any
84 keyboard.)
2
MEAP application
System System driver Application
with VID/PID
driver not supported
supported / conventional declared in
application application Manifest for B
YES
NO
YES
NO
YES
NO
YES
NO
YES YES
NO
YES
NO NO
YES YES
NO
YES YES
NO
T-2-79
MEMO:
The factory shipment default setting is to enable the use of native (main unit
functionality) USB keyboards. Therefore, in order to use MEAP application keyboards,
[Use MEAP driver for USB input device] under [System management settings (initial
settings/ registration)] needs to be set to ON (factory shipment setting is OFF).
Operations change as described below in accordance with ON/ OFF settings.
ON: when using MEAP application keyboard
•
OFF: when using native (main unit functionality) keyboard (factory shipment default)
•

Initialization of MEAP driver priority registration

When any trouble occurs regarding USB driver settings and it is necessary to reset the setting
information, you can reset the MEAP driver preference registration by using service mode.
Steps to initialize preference use registration
1) Start [SERVICE MODE] in Level 1.
2) Press [COPIER] > [Function] > [CLEAR] > button.
2-146
F-2-233
2-146