2
When [i] button is touched, detailed information is appeared.
2
F-2-248
F-2-248
The following settings i.e. RGW-PORT and RGW-ADR in servicemode must not be change
unless there are specific instructions to do so. Changing these values will cause error in
communication with UGW.
F-2-249
F-2-249
c. Select COM-TEST and then touch [OK]. This initiates the communication test between
the device and the UGW. If the communication is successful, OK! is displayed. If NG! (failed)
appears, refer to the troubleshooting guide and repeat until OK! is displayed.
2-157
F-2-250
F-2-250
F-2-251
F-2-251
2-157