Setting Up The Network - Canon imageRUNNER ADVANCE C5045 Series Service Manual

2

Setting Up the Network

To support a MEAP-enabled iR device via network (SMS, etc.), set up the network setting on
the touch panel of the iR device (this setting is [ON] by default).
1) Press [Settings/Registration] button, select [Preferences]> [Network]>[TCP/IP Settings]>
[Use HTTP] and press [On]button.
2
MEMO:
When System Manager ID and PIN are set, the menus under [Network] are gray-out
and cannot be selected.
In such cases, return to Top screen and press [Log In] button shown on the lower left to
log in as System Manager for setup.
MEMO:
When using SSL, press [Settings/ Registration] button, select [Management Settings]>
[License / Other] > [MEAP Settings] > [SSL Settings] and press [On] button. (This
setting is applied to SSL setting on RUI. Vice versa, [On] set for SSL on RUI is also
applied to the touch panel.)
When [Use SSL] is set to On, the message dialog, [The Default Key is not set. Check
the Key and Certificate List settings in Certificate Setting.], is shown. Press [OK] button
for this message.
F-2-158 F-2-158
2) Press [OK] button to return to Main Menu screen.
3) Restart the device.
2-108
2-108