Steps To Service Call Button Settings - Canon imageRUNNER ADVANCE C5045 Series Service Manual

2
2

Steps to Service Call button settings

In order to display a repair/ service call button on LUI, enter Servicemode, then select
COPIER > Option > USER > SCALL-SW. and then set values as ON(1.) The default value is
OFF(0.)
If the function becomes effective, [Request] and [cancel] button will be shown on the bottom
of the counter check screen.
From the screen, if a user touches the button [Request], the notice through which it passes to
UGW will be tried, and the following messages will be displayed. One [Request] is touched,
the notice to UGW will be tried and below guidance will be displayed.
F-2-252 F-2-252
After the service completion, service person in charge sets the completion flag ("1") from
service mode > COPIER > Option > USER > SCALLCMP. If sets, the completion (pseudo
alarm) will be notified to UGW, and Service Call button will be reset
Status
The call will be sent, wait a while.
Request starts
The call has been sent. To cancel calling, touch
Done
the [Cancel request]
Failure The calling is failed.
In processing - (No message)
2-158
User Message
T-2-86 T-2-86
2-158