Oce CS520 User Manual page 213

The machine power will be turned off automatically 5 minutes after this
message is shown if a password is not entered.
The Timer Interrupt password is not factory set and must be entered by the
Key Operator.
In the event the Timer Interrupt password has not been entered by the Key
Operator, the following message will display instead.
Input copy time
0 hour(s) 05 minute(s)
When the above message displays, proceed to step 4 .
2. Enter the password.
Enter a 4-digit number Timer Interrupt password using the keypad on the
control panel.
For setting the Timer Interrupt password, see p. 14-432.
If an invalid password is entered, continue by entering the valid 4-digit
password.
START
3. Press [
The following message will be displayed on the Basic Screen.
Input copy time
0 hour(s) 05 minute(s)
4. Set the hour for the interrupt use.
Enter a 1-digit hour (ex. 3 hours is 3) using the keypad on the control panel. (0
~ 9)
START
5. Press [
6. Set the minute for the interrupt use.
Enter a 2-digit minute (ex. 7 minutes is 07) using the keypad on the control
panel. (00 ~ 59)
Entering a number smaller than 5 will set the minute at 5.
START
7. Press [
Copying is available until the set time is up.
8. When Timer Interrupt of the copier is finished, press [
SAVER ON/OFF
The copier returns to the OFF condition and copying is again disabled.
Programmed Shut-Off (Weekly Timer)
].
].
].
] for one second or longer, then release it.
POWER
8-213