Oce CS520 User Manual page 118

Output Mode for Machine with Finisher
Specification for Output Modes with Finisher
/ Incompatible with Sort mode: Using platen glass (unless Image Insert, Dual
Page, or Platen store mode is used), Fold, Stitch & Fold, Three-Fold,
Trimming,
/ Incompatible with Staple mode: Using platen glass (unless Image Insert, Dual
Page, or Platen store mode is used), Fold, Stitch & Fold, Three-Fold,
Trimming
Using excessively curled paper or some types of thin paper in Staple mode
may cause poor results in arrangement of the stapled sets.
/ Incompatible with Group mode: 1)2 or 2)2 mode using platen glass (unless
Platen store mode is used), Proof Copy, Fold, Stitch & Fold, Three-Fold,
Trimming, Sheet/Cover Insertion, Chapter, Combination, Booklet, Image
Insert, Repeat
/ Incompatible with Group using Secondary (sub) tray: 1)2 or 2)2 mode using
platen glass (unless Platen store mode is used), Proof Copy, Fold, Stitch &
Fold, Three-Fold, Trimming, Punch, Cover sheet feeding, Sheet/Cover
Insertion, Chapter, Combination, Booklet, Image Insert, Repeat
/ Incompatible with Face Up exit: 1)2 or 2)2 mode using platen glass, Fold,
Stitch & Fold, Three-Fold, Trimming, Cover sheet feeding
1. Close the RADF securely, then press [
Check that the Sort mode icon is displayed and the
highlighted in the OUTPUT area.
Key Operator can change the initial output mode. See p. 14-409.
2. Select the desired output mode.
To set output to the Primary (main) tray (except Staple): proceed to the next
step.
To set Staple mode: proceed to step
To set output to the Secondary (sub) tray: proceed to step
3-118
AUTO RESET
OUTPUT MENU
4 .
].
key is
5 .