Oce CS520 User Manual page 133

Checking Feature Selections / Proof Copying (Check Mode)
PROOF COPY
6. Press [
on the Check Screen.
A sample copy will be output.
• Press [
image data will not be deleted from memory.
• You cannot change or release selections that appeared dimmed after
proof copying.
• When the copy result is satisfactory, proceed to the next step.
• When any setting change is required, return to step
copying, as required.
If the desired selection cannot be changed, press [
data in memory, then press [
7. Change the print quantity, as required.
Proof copy can be performed as needed, until the print quantity amount on
the Basic Screen reaches zero. (Note that the print quantity amount on the
Check Screen does not change.)
If required, change the print quantity on the Basic Screen.
START
8. Press [
If the print quantity is not changed, the copier will output the rest, minus the
sample sets.
When the finisher / trimmer unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied sets
as they exit; otherwise, mishandled paper will occur.
] on the control panel or touch
STOP
] to suspend the proof copying. In this case, the scanned
AUTO RESET
].
PROOF COPY
4 , then repeat proof
STOP ] to delete all the
] to restart the job setting.
4-133