C. Checking The Operation - Canon GP605 Service Manual

CHAPTER 11 INSTALLATION
C. Checking the Operation
1) If the Communications Control Board-A1
or the Interface Board-B1 is not to be con-
nected (not requiring the Power Supply-
A1), go to step 4).
Connect the connector [1] of the power
supply to the connector [2] of the control-
ler securely as shown.
Check to make sure that the cord is in the
groove of the board.
2) Connect the power supply to the power
plug, and check to make sure that LED1
of the controller turns on.
11-42
COPYRIGHT © 1999 CANON INC.
[2]
Groove of the board
Figure 11-C601
LED1
LED1 LED2 LED3
LED4 LED5
JC5
J5
6 1 6
SW1 ON
Figure 11-C602
CANON GP605/605V REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[1]
SW2
SW3
LED6
JC8
JB2
JC6
JC9
CPU
IPC
SW4
1
SW5 ON
JA1
JA2
JB1