Canon GP605 Service Manual page 533

No.
10 (This step is for the 120V model only.)
Perform the following while toner is
being supplied.
• Mount the document tray to the copier's
right using the two stepped screws that
come with the unit.
11 When toner supply operation has ended,
place the Test Sheet on the copyboard,
and make copies to check copy images.
Images on the first ten copies or so may
be soiled because of toner falling from the
drum separation claws. Soiling should
stop as more copies are made.
Check to make sure that pick-up
operation from each cassette is normal.
12 Make double-sided copies to check the
operation.
13 Make settings for standard mode in user
mode and service mode to suit the user's
needs.
14 Press the Reset key twice to end service
mode.
15 Clean up the area around the copier.
16 Move the copier to the site of installation,
and fix the copier in place using the
adjusters.
17 If you need to install accessories, install
them now according to the instructions
given in the respective Installation
Procedures.
18 Fill out the Service Sheet.
COPYRIGHT © 1999 CANON INC.
Work
CANON GP605/605V REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 INSTALLATION
Remarks
Document tray
• Make sure that there is no abnormal noise.
• Check the copy image at each default
reproduction ratio.
• Make sure that as many copies as set are made.
• If a discrepancy is noted between left and right,
correct by adjusting the rear height of the primary
charging wire.
• Make sure that all copying operations are correct.
For details of service mode, see the VIII. in chapter
13.
Screws
11-19