Canon GP605 Service Manual page 560

CHAPTER 11 INSTALLATION
Caution:
1. If SW5-4 of the DIP switch on the
controller is set to OFF, group control
is disabled, and the following is indi-
cated:
Figure 11-C608
2. If the copier's memory is used for ID
input (using the copier on its own), the
exiting ID Nos. may be used for the
controller. Perform the following:
Drawing the ID Nos.
a) Set the DIP switch (SW1) of the controller
as follows:
b) Press the switch SW4 on the controller.
In response, LED5 turns on momentarily.
c) Check LED5; it should turn on to indicate
that the data has been drawn.
Otherwise, LED5 will flash. Press the
switch SW4 once again, and see that
LED5 turns on.
The copier cannot discharge paper while
data is being drawn.
d) Set the DIP switch (SW1) on the control
as follows (LED5 should turn off):
11-46
COPYRIGHT © 1999 CANON INC.
SW1
Table 11-C602
LED1 LED2
LED1 LED2 LED3
LED4 LED5
LED5
6 1 6
SW1 ON
SW1-3 SW1-2 SW1-1
Figure 11-C609
SW1
Table 11-C603
CANON GP605/605V REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
bit Position
1,2 ON
3 OFF
LED3
SW2
SW3
LED6
JB2
SW4
1
SW5 ON
SW4
bit Position
1, 2, 3 OFF
JA1
JA2
JB1