Canon GP605 Service Manual page 6

CHAPTER 12 Maintenance and Servicing provides tables of periodically replaced
parts and consumables/durables and scheduled servicing charts.
CHAPTER 13 Troubleshooting provides tables of maintenance/inspection, standards/
adjustments, and problem identification (image fault/malfunction).
APPENDIX contains a general timing chart and general circuit diagrams.
The descriptions in this Service Manual are subject to change without notice for
product improvement or other purposes, and major changes will be communicated in the
form of Service Information bulletins.
All service persons are expected to have a good understanding of the contents of this
Service Manual and all relevant Service Information bulletins and be able to identify and
isolate faults in the machine.
This Service Manual is prepared so that a full understanding may be attained when it
is used side by side with the separately available Copier Basic Series. Refer to the
appropriate section of the document when prompted as follows:
EX.
Volume 3>Chapter 6>VI.A.2. "Cleaning the Charging Wire"
The Copier Basic Series is a combination of descriptions on the existing technologies
used in Canon copiers. It consists of the following seven volumes, and is intended to
supplement the contents of Service Manuals:
Volume I Introduction Fundamental Technology
Volume II Applied Technology Analog Copiers
Volume III Applied Technology Digital Copiers
Volume IV Applied Technology Color Copiers
Applied Technology Accessories
Volume V
Volume VI Applied Technology Controllers
Volume VII Appendix Product Line and Accessories
ii
COPYRIGHT © 1999 CANON INC. CANON GP605/605V REV.0 JAN . 1999 PRINTED IN JAPAN (IMPRIME AU JA
PON)