Canon GP605 Service Manual page 540

CHAPTER 11 INSTALLATION
3) Disconnect the shorting connector from
the control panel cable; lead the cable of
the control card through the wire saddle,
and connect it to the connector. (You will
not be using the shorting connector.)
4) Secure the control panel in place to the
copier.
5) Remove the protective sheet from the con-
trol panel label of the control card.
6) Attach the control panel label to the con-
trol card.
7) Connect the connectors and mount the
covers that have been disconnected or re-
moved.
8) Turn on the copier's main power switch
and the control panel switch; then, check
the operation of the control card.
11-26
COPYRIGHT © 1999 CANON INC.
Shorting connector
Remove
Connect
Figure 11-411
Figure 11-412
CANON GP605/605V REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Wire saddle
Control panel label