Checking The Developing Assembly - Canon GP605 Service Manual

E.

Checking the Developing Assembly

No.
1 Open the multifeeder tray, and remove the
screw from the door tape.
2 Take out the developing assembly from
the shipping box that comes with the
copier.
Turn the developing assembly cylinder
gear by hand, and check the cylinder
surface for damage.
3 Holding the center of the developing
assembly (pocket of the grip), mount it in
the copier. Then, connect two connectors.
Caution:
When mounting the developing
assembly, try inserting it from high
above, taking care not to bring the
developing cylinder into contact
with the metal plate of the develop-
ing assembly base.
4 Secure the developing assembly locking
unit in place with six screws (M4 × 6;
black; attachment).
5 Mount the door tape of the multifeeder
with a screw.
COPYRIGHT © 1999 CANON INC.
Work
CANON GP605/605V REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 INSTALLATION
Remarks
Door tape
Developing
assembly
Connectors
Developing assembly
Screws
Screws
Screws
11-13