CHAPTER 13 TROUBLESHOOTING
9.2 Position of the Fixing Cleaning Belt Solenoid (SL2)
a.
If the Fixing Cleaning Belt is New
Adjust the position of the solenoid using the screw [1] so that the movement of the drive lever
will be over a distance of 8.6 mm.
Solenoid (SL2)
[1]
b.
If the Fixing Cleaning Belt Has Been in Use
Before removing the solenoid, take note of the position A of the drive lever when the solenoid
is on. After replacing the solenoid, adjust the position using the screw [1] so that it will be the same
as it was before removal when the solenoid turns on.
Solenoid (SL2)
13-26
COPYRIGHT © 1999 CANON INC.
Figure 13-D211a
[1]
Figure 13-D211b
8.6mm
A
CANON GP605/605V REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)