Selecting A Source; Selector Knob Method; Category Button Method - GRASS VALLEY L-S series Instruction Manual

Section 6 — L-S Series Panel Operation

Selecting a Source

Selector Knob Method

Category Button Method

136
3. Use the Category buttons to enter the number of that Destination.
Alternatively, you can use the Selector knob to scroll through the
available Destinations. If the entry is valid, the name of the Source will
appear in the Preset window in yellow, and the category/number for
the Source will be shown in blue.
4. When the desired Destination is displayed, press
Note If a Destination has been Protected or Locked by another panel, the Protect/
Lock button will illuminate steady amber (Protect) or red (Lock) and the Des-
tination will not be able to be switched. To continue, the Destination must be
unprotected or unlocked by the panel that set the protect or lock (the name
of that other panel will be displayed in the menu).
CAUTION If the Select button is blinking, Sources will switch as the knob is turned (see
Scroll Take Mode on page
Sources with the following methods.
1. If necessary, press
2. Use the selector knob to scroll through the available Sources displayed
in the Preset window.
3. When the desired Source is selected, press
switched to the currently controlled Destination.
If your Jupiter system and panel has been configured with categories you
will be able to use the 16 Category buttons on the right to select Sources.
1. If necessary, press
2. Press one of the 16 Category buttons on the right to select the desired
category (VTR, for example). The Category buttons then shift to
number selection mode.
3. Use the Category buttons to enter the number of that Destination.
Alternatively, you can use the Selector knob to scroll through the
available Destinations.
4. When the desired Source is selected, press
switched to the currently controlled Destination.
JUPITER L-S and LCD Series Control Panel Instruction Manual
141). Make sure Scroll Take is OFF before selecting
to take the panel to its home state.
Clear
to take the panel to its home state.
Clear
.
Select
. That Source will be
Take
. That Source will be
Take