GRASS VALLEY L-S series Instruction Manual page 84

Section 5 — Connecting the L-S, LCD Panel
84
Figure 46. S50 Control Panel
Buttons 1-50
Follow these steps to change the Connection Type setting using the S25 or
the S50 panel's menu:
1. Press the Destination button that is in the upper-right corner and the
Destination button in the lower-left corner at the same time, for
approximately three (3) seconds
The
Serial Mode Cancel
light up red.
The current Panel ID button will be high tally amber if the ID is between
1 and16. The button will not light up amber if the range is greater than
16.
Figure 47. S25 Front Panel
Panel ID Button Serial Mode Cancel Button
2. Select one of the Panel ID buttons (1-16) to assign the Panel ID if you
want to change the panel's ID. The selected button will then show high
tally amber.
The
Serial Mode Accept
corner) will then blink green
Figure 48. Serial Mode Accept Button
JUPITER L-S and LCD Series Control Panel Instruction Manual
(Figure 47).
button, button 25 (S25), or button 50 (S50), should
Press and Hold these Buttons
button (the Destination button in the lower-right
(Figure 48).
Serial Mode Accept Button
S50
Destination Buttons