GRASS VALLEY L-S series Instruction Manual page 18

Safety Summary
18
Do not operate with suspected equipment failure
or equipment failure, have the equipment inspected by qualified service
personnel.
— If mains switch is not provided, the power cord(s)
Ensure mains disconnect
of this equipment provide the means of disconnection. The socket outlet
must be installed near the equipment and must be easily accessible. Verify
that all mains power is disconnected before installing or removing power
supplies and/or options.
— Route power cords and other cables so that they ar not
Route cable properly
likely to be damaged. Properly support heavy cable bundles to avoid con-
nector damage.
Use correct power supply cords
meet all North American electrical codes. Operation of this equipment at
voltages exceeding 130 VAC requires power supply cords which comply
with NEMA configurations. International power cords, if provided, have
the approval of the country of use.
Use correct replacement battery
reduce the risk of explosion, check polarity and replace only with the same
or equivalent type recommended by manufacturer. Dispose of used bat-
teries according to the manufacturer's instructions.
Troubleshoot only to board level
populated with surface mount technology (SMT) components and applica-
tion specific integrated circuits (ASICS). As a result, circuit board repair at
the component level is very difficult in the field, if not impossible. For war-
ranty compliance, do not troubleshoot systems beyond the board level.
JUPITER L-S and LCD Series Control Panel Instruction Manual
— If you suspect product damage
— Power cords for this equipment, if provided,
— This product may contain batteries. To
— Circuit boards in this product are densely