Selection Options; Select Destination Mode - GRASS VALLEY L-S series Instruction Manual

Line #1:
L:LCD16

Selection Options

Select Destination Mode

JUPITER L-S and LCD Series Control Panel Instruction Manual
Figure 94. Locked Destination Displayed
L:LCD16
PINP-004
OUT-255
You may have access to numerous Destinations or outputs. The Select Des-
tination mode was designed to quickly find a specific Destination. The
Select Destination mode can be accessed from the main menu's "select des-
tination?" button. The Select Destination mode is also available for use in
the following modes: XY-Mode, Multi-Destination mode, Single-Destina-
tion mode, and Level mode.
Note The Select Destination mode is not available in the Category entry and the
B.P.S. modes.
There are two methods of selecting a Destination, Direct Entry and Cate-
gory Entry. Each of these methods will be explained below. Both of these
Instruction steps assume the
pressed. The LCD16 is different from the LCD48 because the LCD48 dis-
plays both the Direct Entry (on the Left half) and the Category Entry (on the
Right half) of the panel. The LCD16 requires the use of
button to switch between the direct entry and category entry modes.
Selecting the Destination using the Direct Entry Method
Follow these steps to select a Destination using the Direct Entry method:
1. Scroll through the available Destinations using the Scroll wheel. The
Destinations will change.
2. Select the Destination by pressing the preferred button. The selected
destination now becomes "Preset source."
The Preset source means that the selected source will be switched to the
destination when the
diately revert back to the previous mode. For example, the Level mode.
button in the Level mode has been
Destination
button is pressed. The panel will then imme-
Take
Basic Panel Operations
Select Destination
175