Table of Contents
Advertisement
4 Use the knob now to scroll through the devices in the category until you see the
desired device in the preset display. (Device names consist of the category mnemonic
followed by a (usually) numeric suffix.
5 At any time, you can press a 'Clear' button to erase the preset entry you have selected.
You might have to press 'Clear' more than once.
Procedure B — Preset a Source Using a Keypad
To preset a source in the preset display of the NV9649 (server):
1 Ensure that the NV9649 is in source mode. Press a 'Source Mode' button or press a
'SRC/DST Mode' button when the panel is in destination mode.
2 Use a category button to select the desired category. The selected category will be
displayed in the preset display. (The panel must have been configured with one or
more category buttons.)
3 After choosing a category, use the panel's keypad to "type in" the index of the desired
device contained in the category. For example, if the category is VTR and the device is
VTR_12, type in 1, then 2. (The panel must have been configured with one or more
suffix buttons, which are category buttons that provide suffixes.)
As you press keys of the keypad, a device that currently matches the string of indexes
will be displayed in the 'Preset' display.
Note also that you can use the knob to scroll forward or back from any point in the
device selection (starting at that whatever index you have entered so far).
During device selection by keypad, certain keys in the keypad become disabled if it
is not possible to use the keys to perform further selection. For instance, if you have
devices numbered 1–16 in a category and you press 2 (e.g., VTR2), all keys in the
keypad become disabled because another digit would create an index of 20, 21, or
similar, which is beyond the range of 1–16.
4 At any time, you can press a 'Clear' button to go back one key press at a time as you
require.
Procedure C — Assign a New Source to a NV9649 Source Button
To assign a new source to a source button of an NV9649's control unit:
1 Ensure that the NV9649 is in source mode. Press the 'Source Mode' button or press a
'SRC/DST Mode' button if the panel is in destination mode.
2 Use procedure A or procedure B described above to select (i.e., preset) the desired
source.
3 Press an 'Assign' button on the NV9649.
4 Press the intended source button — in the intended control unit of the intended
NV9649. The software assigns the source selected at the NV9649 to that button. The
source text appears on the button's LCD.
Procedure D — Assign a New Destination to a NV9649 Control Unit
To assign a new destination to a control unit of an NV9649:
1 Ensure that the NV9649 is in destination mode. Press the 'Destination Mode' button or
press a 'SRC/DST Mode' button if the panel is in source mode.
NV9649
User's Guide
113
Advertisement
Table of Contents
