Source Swap Mode; Breakaway Switching; Single Source Breakaway - GRASS VALLEY L-S series Instruction Manual

Source Swap Mode

Breakaway Switching

Single Source Breakaway

JUPITER L-S and LCD Series Control Panel Instruction Manual
When Source Swap is ON, the panel will preset its previous Source after a
Take. This permits flip-flop switching.
1. Press Select . The display windows will display various modes.
2. Rotate the selector knob to
3. Scroll to
Source Swap
4. Press to turn Source Swap ON or OFF.
Select
The panel exits Config Mode and operates in the new Source Swap mode.
Breakaways takes of individual levels can be accomplished by selecting the
level(s) to switch, and then selecting a Source.
Breakaways can be disabled on the CP Level Set table by setting the Break
Flag for each level to `N.'
The following procedure is used to switch a single Source as a breakaway.
For example, switching left and right audio but not video.
1. Check that the desired Destination appears in the Destination window.
If not, see Selecting a Destination to be Controlled on page
2. Toggle OFF the Level button(s) for the level(s) you do not want to
switch. The bottom row of the Status window will indicate the highest
numbered level that will witch, in amber.
3. Select a new Source for the levels selected and press
Source on page 136).
The Source will switch only on the selected levels, while the non-selected
levels will remain at the previously selected Source.
• To verify the breakaway status, see
page 138 below.
• If sticky mode is OFF, the panel will return to "all levels selected" after
each switch and show the status of Level 1 (typically the video level). If
sticky mode is ON, the level(s) selected will remain the same for subse-
quent switches. For more information about sticky mode, see
Note If the level indicator is blank, the Source may not exist on that level (For
example, audio from a camera).
and press
Panel Config?
. Its current status will be reported (-ON- or -OFF-).
Checking Breakaway Status on
SXY Control Panel
.
Select
135.
(see Selecting a
Take
page 139.
137