Panel Config Button; Panel Setup Button; Panel Info Button - GRASS VALLEY L-S series Instruction Manual

Section 7 — LCD Introduction

Panel Config Button

Panel Setup Button

Panel Info Button

150
The Panel Configuration menu will appear when the
pressed. The Configuration menu is comprised of the following:
• : This button is in the #1 location. Pressing the
Sticky Level button
will turn sticky levels ON. When Sticky Levels mode is ON,
Level button
after a breakaway only the levels that were selected for that breakaway
will remain activated. Subsequent takes will switch only those levels.
Pressing the button again will turn the Sticky Levels mode OFF. In level
mode, with sticky level OFF, the levels are not selected after a take by
default.
•
Sticky Destination button:
Sticky Destination button
Destinations that are selected with Sticky Destinations feature turned
ON will remain selected until the selection is canceled by the user.
• : This button is in the #16 location. The
Config Menu button
is for information only.
The Panel Setup menu will appear when the
The Setup menu has the following buttons:
•
Setup Panel ID button
will show the
Panel ID button
ID is shown on line 2; the ID that will be changed is shown on line 3.
Move the Scroll wheel to change the ID. Moving the wheel to the left
will show smaller numbers, moving to the right will show greater num-
bers, than the current ID. When a new ID number is being selected, the
button will turn green in color. Pressing button #16 will make the new
ID active for that panel.
•
Set Memory to defaults button
Set Memory to defaults button
was shipped with. Pressing any of the five buttons will reset the speci-
fied memory: All, Network, Host, Panel and Buttons.
• Enter Diagnostics? button
Enter Diagnostics? button
two buttons on the panel to return to normal panel operations.
• : This button is in the #4 location. Pressing the
Panel RESET button
will restart the panel.
RESET button
• : This button is in the #16 location. The
Setup Menu button
is for information only.
The Panel Information menu will appear when the
pressed. There is nothing to select in the Panel Information menu, these
JUPITER L-S and LCD Series Control Panel Instruction Manual
This button is in the #2 location. Pressing the
will turn the sticky Destination feature on or off.
: This button is in the #1 location. Pressing the
button (#16). The Current Device
Change ID
: This button is in the #2 location. Pressing the
will restore the memory setting that the panel
: This button is in the #3 location. Pressing the
will start the panel diagnostic mode. Press any
Panel Config button
Sticky
Config Menu button
is pressed.
Panel Setup button
Setup Menu button
is
Panel Info button
is
Setup
Panel