Select Override Mode - GRASS VALLEY L-S series Instruction Manual

Section 11 — LCD Series Panel Operation

Select Override Mode

178
Note The Select Sequence mode requires that a least one sequence is assigned
using the Jupiter configuration.
Follow these steps to select a sequence or a salvo:
1. Press the Scroll wheel to go to the Main menu.
2. Press the
Select Sequence?
These buttons will be pink and the name of the sequence will be on line
#2.
3. Select the preferred Sequence; use the Scroll wheel to cycle through all
the available "sequence" pages as needed. The panel will return to the
last selected mode.
An Override is used to perform a pre-defined Take. The Take can include
Input, Output and Levels. Overrides can be done at any time, regardless of
which mode the panel is in.
Note The Select Override mode requires that a least one override is assigned using
the Jupiter configuration.
Follow these steps to select an Override:
1. Press the Scroll wheel to go to the Main menu.
2. Press the
Select Override?
These buttons will be blue and the name of the override will be on line
#2.
3. Select the preferred Override; use the Scroll wheel as needed.
The panel will NOT revert back to the previous panel mode after each
selected override. This feature allows you to do several overrides within a
single session. Press the Scroll wheel to go to the Main menu to exit.
JUPITER L-S and LCD Series Control Panel Instruction Manual
button. The Sequence menu will then appear.
button. The Override menu will then appear.