GRASS VALLEY L-S series Instruction Manual page 190

Appendix C — GPI/O
190
3. Align the GPI/O accessory to the S, L panel by aligning the notch in the
GPI/O and the stud on the S, L panel.
Figure 99. Notch Alignment
Align the "notch"
4. Replace the four screws in the panel, securing the GPI/O accessory to
the panel.
Figure 100. The Installed GPI/O
5. Connect the cables to the GPI/O's 9-pin D connectors.
Now that the GPI/O connection plate is connected, the software will
become active and you can configure your connections.
JUPITER L-S and LCD Series Control Panel Instruction Manual