Serial Protocol Table Entries; Mpk Table Entries - GRASS VALLEY L-S series Instruction Manual

Section 5 — Connecting the L-S, LCD Panel

Serial Protocol Table Entries

MPK Table Entries

MPK Devices
MPK Device
Devices Type
1 CP1 CPES-SER
CP2 CPES-SER
2
16 CP16 CPES-SER
CP17 CPESXTND
17
78
When an L-S or LCD Panels is connected to a CM-4000 serial port (and
operated in Serial mode), the CM-4000 serial port must be configured for
"ESCP" protocol using the Serial Protocol table. The Baud rate should be
set at 115K. Use the CPES-SER type for panels to use up to 98 categories.
Although the L-S or LCD Panels are not actually an MPK-type panel (it has
an on-board microprocessor and does not use the Message Per Key stroke
protocol), the MPK table is used for configuration purposes. An example is
shown below in Figure
Note If the phrase, "Follows the same rules as L/S/LCD panels," is shown below
the settings are the same as the ones described in the
figuration section of this manual.
Figure 38. MPK Devices Table
Pass
Expansion Board Port Address
word
CM1 1 01
CM1 02
1
1
CM1 16
CM1 01
MPK Devices - This column is used to create a name, up to eight characters
in length, for each L-S or LCD Panels. This name must be unique system-
wide.
Type - Select type CPES-SER for panels wanting to use up to 98 categories.
Note CPES-SER is the serial equivalent to the CP-ESXTND type.
Expansion - Not used for L-S or LCD Panels (leave unchecked).
Password - Password level only needs to be entered if you wish to disable
the Configuration and Setup menus on the Control panel. See the
the Configuration and Setup Menus on the Control Panel
Board - The name of CM-4000 connected to this L-S or LCD Panels. The
source of this name is the Jupiter Network Description table.
Port - The port number that is configured for ESCP to which the panel is
connected. ESCP is defined in the Serial Protocol Table.
Address - The panel address from 1 to 16. This address must be unique for
panels sharing the same CM-4000 serial port.
JUPITER L-S and LCD Series Control Panel Instruction Manual
38.
Input Sets In Panel Output Sets
CPOUT
CP_IN
CP_IN CPOUT
CP_IN CPOUT
CP_IN CPOUT
Jupiter System Con-
Out Panel Level Set Overide Set
CP_LEV
CP_LEV
CP_LEV
CP_LEV
Disabling
section on page
Sequence Set
63.