Alternate Mode Operation; Multiple Destination Mode - GRASS VALLEY L-S series Instruction Manual

Alternate Mode Operation

Multiple Destination Mode

JUPITER L-S and LCD Series Control Panel Instruction Manual
• Locking a Destination on page 105
• Breakaway Switching on page 106
• Sticky Levels Mode on page 99
• Executing a Sequence (Salvo) on page 108
• Source Swap Mode on page 108
• Button Assignment on page 109
• L-S Front-Panel Service Modes on page 183
Alternate mode can be useful when all 100 buttons to the left of the status
displays have been assigned to Sources, Destinations, sequences, or levels
and the operator wants to make additional assignments on a temporary
basis. Alternate mode allows the top six buttons in the right-hand button
cluster to be used for this purpose.
Figure 77. Alternate Mode Buttons
Button assignments must be made prior to entering Alternate mode. See
Button Assignment on page
Activating Alternate Mode
1. Press .
Menu
2. Use the arrow buttons to scroll to
Up/Down
3. Use the arrow buttons to scroll to
Up/Down
will report its current status (OFF or ON).
4. Press to toggle the state and exit Menu mode.
Take
This function allows gang switching where the same Source is switched to
multiple Destinations with a single Take. When active, this mode allows the
selection of multiple assigned Destination buttons simultaneously.
109.
PanelConfig?
Alternate mode
S100 Control Panel
Panel
ID
Protect/
Lock
and press
Take.
. The window
133