GRASS VALLEY L-S series Instruction Manual page 114

Section 6 — L-S Series Panel Operation
114
2. Press the soft button for
state and the panel will exit Menu mode.
Breakaways can be disabled on the CP Level Set table by setting the Break
Flag for each level to `N.'
Deselect Levels Method
1. Confirm the desired active Destination is shown in yellow in the
Destination window and Level Select mode is
2. Press the soft buttons for the levels you do NOT want to switch so the
buttons are turned off. To move beyond the first 4 levels, use the
arrow buttons.
3. Select a Source, using one of the methods described under
Source (Single Destination Mode) on page
Source will appear in Blue.
• If the level indicator is blank, the Source may not exist on that level
(For example, audio from a camera).
4. Press . The Source will switch only on the selected levels to the
Take
controlled Destination, while the non-selected levels remain at the
previously selected Source. The level windows will indicate the status
of the first 4 levels.
• If Sticky Levels is off, after the Take all levels will automatically be rese-
lected (their soft buttons will illuminate). If Sticky Levels is on, only the
levels involved in the last Take will remain selected.
Select Levels Method
This method is the reverse of the above procedure.
1. Confirm the desired active Destination is shown in yellow in the
Destination window and Level Select mode is
2. Toggle ON the soft button(s) corresponding to the level(s) to be
switched. To move beyond the first 4 levels, use the
buttons.
3. Select a Source using one of the methods described under
Source (Single Destination Mode) on page
4. Press . The Source will switch only on the selected levels, while the
Take
non-selected levels will remain at the previously selected Source.
JUPITER L-S and LCD Series Control Panel Instruction Manual
. The mode will toggle to the other
Level Select
112. The selected (i.e., preset)
112.
.
ALL_ON
Up/Down
Selecting a
.
ALL_OFF
arrow
Up/Down
Selecting a