Coolant Pump Cover Removal; Left Engine Cover Removal; Gearbox Selector Shaft Oil Seal Removal/Installation - Husqvarna TR 650 TERRA 2013 Workshop Manual

1
3
3
1
Workshop Manual Ed.09-2012
GENERAL ENGINE PROCEDURES
TR 650 TERRA 2013 - TR 650 STRADA 2013

Coolant pump cover removal

- Remove the pipe (1) from the pump cover (2).
- Remove the screws (3).
3
- Remove the coolant pump cover (2) and its gasket.
2
H11760
- Reassemble all parts, in the reverse order and tighten screws to recommended
torque.
H11761

Left engine cover removal

- Remove the water pump cover, the clutch cover and the left casing as de-
scribed in the relative chapters.
- Remove the water pump (1) and oil seal (2) of the gearbox selector shaft as
described in the relative section.
- Replace the casing (3) and reassemble everything following steps in inverse
order.
2
H11512

Gearbox selector shaft oil seal removal/installation

- Using an appropriate tool carefully remove the oil seal from the inside diameter
(1).
- Lubricate the seal lip of the new oil seal; then fit it on the cover, using an
appropriate tool.
- Protect the oil seal lip from possible damage by winding, for example, mask-
ing tape around the shaft broaching.
1
H11513
Check gasket condition when refitting and replace if necessary.
F1.4