Table of Contents
Advertisement
17 SERVICE WORK ON THE ENGINE
17.3
120
Changing the engine oil and oil filter, cleaning the oil screen
Warning
Danger of scalding Engine and gear oil get hot when the motorcycle is operated.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Drain the engine oil while the engine is at operating temperature.
W00543-10
W00540-10
W00542-10
Preparatory work
–
Park the motorcycle on a level surface.
Main work
–
Position an appropriate container under the engine.
–
1
Remove screw plug
with oil screen and the O-rings.
–
2
Remove oil drain plug
–
3
Remove oil drain plug
Info
Do not remove screw
–
Allow the engine oil to drain completely.
–
Thoroughly clean the parts and the sealing surfaces.
–
Mount and tighten oil drain plug
new seal ring.
Guideline
Oil drain plug with
magnet
–
5
Position oil screen
with the O-rings on a pin wrench.
–
Position the pin wrench through the drill hole of the screw
plug in the opposite section of the engine case.
–
Push the oil screen all the way into the engine case.
with the magnet and seal ring.
with the magnet and seal ring.
4
.
3
with the magnet and a
M12x1.5
20 Nm (14.8 lbf ft)
Advertisement
Table of Contents
