Pumps; Oil Pump Removal/Installation - Husqvarna TR 650 TERRA 2013 Workshop Manual

GENERAL ENGINE PROCEDURES
TR 650 TERRA 2013 - TR 650 STRADA 2013
A
B
H11652
11
8
11
9
10
7

PUMPS

Oil pump removal/installation

Remove the clutch as described in the relevant paragraph.
A) Supply pump
B) Intake oil pump
Removal:
- Remove the retaining ring (2).
- Disassemble the gear (3).
- Remove the pin (4).
- Remove the washer (5).
- Loosen the screws (6) and remove the oil pump cover (7).
- Remove the pin (8), piston (9) and rotor (10).
Oil pump check
Use a feeler gauge to check the clearance between the rotor (10) and casing;
maximum allowed clearance is 0.25 mm (0.01 in.).
Replace the pump if the clearance is greater.
Installation:
- Check pin integrity (11) and (4), and replace if ruined.
- Refit pin (11) onto pivot (8) and insert into the casing.
- Clean the parts and lubricate the engine (10) and the piston (9) with motor
oil and fit into the pin (8), making sure that the reference dot on the engine
10) and the piston (9) fit and that is facing the outside.
Make sure that the pin is positioned properly (11) on the piston (9).
- Fit the cover (3) tightening the screws (6) to torque with Loctite 243.
- Insert the washer (5) into the pivot (8) and mount the pin (4) onto the pivot
(8).
- Fit the gear (3) and retainer ring (2).
8
9
10
6
5
4
F1.17
7
6
4
5
3
2
3
2
Workshop Manual Ed.09-2012
H11563